This is a handy reference to have for whenever we need to do wheel repairs on our Honda HRU 216 lawn mower. Maintenance is required on these self propelled wheel units, and sometimes we can forget which order things go in, sometimes parts can get stuck in place so that the new operator may not clearly see how things go together or how they should come apart, parts break, and so on.
So here’s the wheel assembly for a Honda HRU 216 lawn mower.
Removing The Wheel
First we need to lock the wheels in place before we put a spanner onto them. This can be done in various ways, I have a little occy strap lying around for just this purpose. This is wrapped around the two bales on the handles.

Next I do the initial loosening of the bolt.
Then the rear end of the lawn mower is lifted a little and supported with a spare paver.
The bolt is then removed and the wheel taken off.
The Drive Assembly Of The Honda HRU 216
It’s very straightforward.

We have the ratchet.
The ratchets come in Left and Right variants for each wheel, the easiest way to tell which is which is to look at which direction the two little arms are facing, if they point right then they are for the right wheel, if the point left then they are for the left wheel. This is a right wheel.

Then we have the pin.
The pin goes through a hole in the axle, and this is what propels the mower forward. These pins break from time to time, and will need to be replaced. I have a ton of old useless drill bits lying around that have no use anymore, so I just cut one to size. The pin goes all the way through the axle.
I once had a pin break and the remaining part seize into position, as this was the first time this happened to me, and without prior experience, I couldn’t tell if the pins were meant to be two pieces and that I was missing one piece.
If a pin becomes seized into place it will be necessary to hammer it out.
Next in line we have a washer, 16mm from memory.
Then after that is the dust cover.
Remember which direction the dust cover is positioned in, if we put the dust cover on back to front then we leave the ratchets prone to becoming damaged and breaking very quickly and repeatedly, which can cost us a small fortune in replacements.
Dust covers, washers, pins, and ratchets all need to be replaced from time to time.
That’s it.
That’s the wheel assembly for a Honda HRU 216 lawn mower.


all articles and images are © copyright
thelawnmowingman.com
